Deep Hole Drill
l Machine with Mitsubishi PLC or LNC CNC is designed for drilling turbine shaft.
l Servo motor and ball screw are used for the feed mechanism to insure smooth and convenience for feed rate adjust.
l Slide ways are heat-treatment t o hardness HRC52 and ground way are based on mechanic cast iron. The Opposite ways and gibes are all Turcite-B plated with hand scraped bearing surface.
l The enhanced ribs in the major construction provides the excellent rigidity.
l Automatic lubrication pump is provided as standard accessory to ensure all bearing surface and screws are well lubricated.
lFour filtration systems (paper filter, magnetic separator chip auger and tank filter) are standard accessories to keep the oil clean.
l The excellent design of oil flow cycle provides plentiful oil to lower the temperature of drilling and drill smoothly.
Ø3- Ø 9mm
Max. drilling length
Max. travel of slide (Z axis)
Ø40× P10 (HIWIN)
Feed motor (AC servo motor)
Cast iron F25C (Heat treatment HRC 52)
Component holding system
Mode of loading and unloading
Component clamping way
6" manual 3-jaw chuck × 2Nos
Clamping range of component size
Mode of operation
Tool rotating & feeding,
Motor for rotating component
Total tank capacity
Delivery LPM (Max.)
High pressure pump
Variable flow pump
Magnetic separator, tank filter
Mode of lubrication
Auto through PLC
Machine total power
- Mitsubishi PLC or LNC CNC x 1 set
- Magnetic separator x 1 ea
- High Pressure pump x 1 set
- Automatic lubrication pump x 1 set
- Manual chucks x 1 set
- Component rotating system x 1 set
- Protection of spindle motor overloading x 1 set
- Outside Oil tank & Oil level gauge x 1 set
- Transformer(220v/415v) x 1 set
- 3 sizes of Guide bush x 1pc
- 3 sizes of Rubber bush x 5pcs
- Tool box x 1 set
- Alarm light x 1pc
- Mechanical & Electrical operation manual in English x 1 set